|
It's just occurred to me that some dust from my earlier fail... In forum Hardware, firmware and software help |
9 months ago |
|
This would allow the seized assembly (nut, bolt, idler mount... In forum Hardware, firmware and software help |
9 months ago |
|
I wonder if something like this would still work properly fo... In forum Hardware, firmware and software help |
9 months ago |
|
Ah - you downloaded them a few days before me! Yes, it's th... In forum Hardware, firmware and software help |
9 months ago |
|
Nor me - but I've encountered galling before. My camper van... In forum Hardware, firmware and software help |
9 months ago |
|
Personally I think the factory tensioner pulley mount is per... In forum Hardware, firmware and software help |
9 months ago |
|
Looking at the remains of the one I had to destroy to get th... In forum Hardware, firmware and software help |
9 months ago |
|
Ah, ok - understood. Meanwhile, while replacing the original... In forum Hardware, firmware and software help |
9 months ago |
|
I meant to add this photo of the partially completed VFA tes... In forum Hardware, firmware and software help |
9 months ago |
|
The silicone is a tight fit inside the bearings, and once fi... In forum Hardware, firmware and software help |
9 months ago |
|
Hmm - no, my comparison of old and new methods was with the ... In forum Hardware, firmware and software help |
9 months ago |
|
Oh dear - my idler gave up the fight on the second VFA print... In forum Hardware, firmware and software help |
9 months ago |
|
Agreed, although in practice there's very little difference ... In forum Hardware, firmware and software help |
9 months ago |
|
Makes sense - so the silicone is acting as a spring, and not... In forum Hardware, firmware and software help |
9 months ago |
|
Your post arrived while I was typing. I don't understand you... In forum Hardware, firmware and software help |
9 months ago |
|
Yes, I get that - you've allowed the idler mount to move (th... In forum Hardware, firmware and software help |
9 months ago |
|
Yes, disappointing, but as Rainer says, every experiment giv... In forum Hardware, firmware and software help |
9 months ago |
|
Hmm - my SE(TM) (Silicone Enhanced) idlers have had an effec... In forum Hardware, firmware and software help |
9 months ago |
|
Don't you have some wet paint you can watch dry? I find thi... In forum Hardware, firmware and software help |
9 months ago |
|
Yes. @Malpan showed some impressive results by just stuffin... In forum Hardware, firmware and software help |
9 months ago |
