Prusa3D Forum

Notifications

Clear all

Chriis

Skupina: Registrovaný

Přidal se: 2018/11/09

Active Member

	Is it around the hole print, or just at one site? Can you me... In forum How do I print this? (Printing help)	před 4 years
	Is the filament sensor on the mmu in the right position? So... In forum Hardware, firmware and software help	před 4 years
	Is the pressure of the screws from the top of the mmu right?... In forum Assembly and first prints troubleshooting	před 4 years
	Look's like an under extrusion. But the picture is not the b... In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

585 Fóra

67.9 K Témata

476.2 K Příspěvky

11 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed