Prusa3D Forum

Notifications

Clear all

Choucroutemelba

Groupe: Enregistré

A(ont) rejoint: 2017/06/22

Active Member

	By the way V3 and V4 update have been posted. There looks l... Dans le forum Others (Archive)	il y a 7 years
	Hi The new duct have been printing with no major issues exc... Dans le forum Others (Archive)	il y a 7 years
	Great ! Happy that could help you. I'll try soon... Dans le forum Others (Archive)	il y a 7 years
	During a deep check of my MK2S to fix my wobble issue, I not... Dans le forum Others (Archive)	il y a 7 years
	yes, I use Slic3r. Do you have experience with both slicers... Dans le forum Others (Archive)	il y a 7 years
	.... By the way, infill overlap is 25% ! Dans le forum Others (Archive)	il y a 7 years
	Hi Fill density is very low (10%) and vertical shels is se... Dans le forum Others (Archive)	il y a 7 years
	Hi Jeffrey It seems the over-extrusion occurs only some mm ... Dans le forum Others (Archive)	il y a 7 years
	Thanks Matthias, Unfortunately I didn't update the firmware... Dans le forum Others (Archive)	il y a 7 years
	Horrible print ! Dans le forum Others (Archive)	il y a 7 years
	Hi I got my MK2S since several month but I haven't got the t... Dans le forum Assembly and first prints troubleshooting	il y a 7 years

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

19 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé