Activité
 
Notifications
Clear all
Chocki
Chocki
Groupe: Enregistré
A(ont) rejoint: 2018/09/27
Prominent Member
2
I use SUNLU PETG at a print temperature of 215 Dec, First la...

Dans le forum General discussion, announcements and releases

il y a 4 years
Even though I know FDM printing has limitations, rather than...

Dans le forum Hardware, firmware and software help

il y a 4 years
Thanks for the info Bobstro, this will be a useful feature.

Dans le forum Hardware, firmware and software help

il y a 4 years
Also take into consideration extrusion widths. With a 0.4mm ...

Dans le forum Hardware, firmware and software help

il y a 4 years
I find that printing with PETG when using 3mm screws, I don'...

Dans le forum How do I print this? (Printing help)

il y a 4 years
Depends on how many filaments you want to dry at once and yo...

Dans le forum General discussion, announcements and releases

il y a 4 years
I assume that you have already let the fan run at full speed...

Dans le forum Hardware, firmware and software help

il y a 4 years
If their suppliers can get the parts to them that is.

Dans le forum General discussion, announcements and releases

il y a 4 years
Oil is great until that time you have a long print (>24 h...

Dans le forum General discussion, announcements and releases

il y a 4 years
Looks very similar 😀 I've been using one of these dehidrato...

Dans le forum General discussion, announcements and releases

il y a 4 years
Already exported all my drawings to local disk. Just install...

Dans le forum General discussion, announcements and releases

il y a 4 years
Biggest difference to noise reduction I found is as Bobstro ...

Dans le forum Hardware, firmware and software help

il y a 4 years
I use a lab glass block like this:/p> (But got it much cheap...

Dans le forum General discussion, announcements and releases

il y a 4 years
Here you go, 30 seconds. Seems to work just fine, but I g...

Dans le forum General discussion, announcements and releases

il y a 4 years
I use 2 x 500g tor 1 x 1000g desiccant bags designed for use...

Dans le forum General discussion, announcements and releases

il y a 4 years
Finally the dryer in Tim's post (The stainless steel one) is...

Dans le forum General discussion, announcements and releases

il y a 4 years
I also think I might try the glue stick on the Buildtak surf...

Dans le forum General discussion, announcements and releases

il y a 4 years
Thanks for the quick reply Charles, so you think I might exp...

Dans le forum General discussion, announcements and releases

il y a 4 years
Finally ordered some Prusament PC blend and it should be wit...

Dans le forum General discussion, announcements and releases

il y a 4 years
I used the following - before the magnets fell out, but will...

Dans le forum Hardware, firmware and software help

il y a 4 years
Page 3 / 49
Partager :