Prusa3D Forum

Notifications

Clear all

Chad Stewart

Groupe: Enregistré

A(ont) rejoint: 2019/08/04

Active Member

	Where to get heated plates Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 5 years
	Ahhhhhh the nut on the extruder door wasn't all the way in -... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Just attempted again with slower speed -- same thing happene... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Yeah was just reading some stuff on NinjaFlex that said do e... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	I'm thinking the bondtech gear is too far from the extruder ... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	This is what I was going for: Attachment removed Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Thanks @joantabb -- that definitely helped but I don't think... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Got the filament. But root problem (filament getting jammed/... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Tried to remove this by unloading and somehow the filament g... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	First time printer -- trying to use NinjaFlex Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

21 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé