Prusa3D Forum

Notifications

Clear all

chad.r2

Skupina: Registrovaný

Přidal se: 2017/08/08

Active Member

	ColorPrint Web Site Not Adding All Color Changes 11/12/2018 In forum Hardware, firmware and software help	před 6 years
	Spoke too soon again...that fix is for the MK2.5 and 3. Wil... In forum Hardware, firmware and software help	před 6 years
	Note, this was from firmware 3.1.0, which I just updated to,... In forum Hardware, firmware and software help	před 6 years
	Continued filament advance AFTER color change In forum Hardware, firmware and software help	před 6 years
	So in ColorPrint webpage, I added a color change at 2.15. H... In forum Improvements (Archive)	před 7 years
	No one else is having this issue? In forum Improvements (Archive)	před 7 years
	Colorprint Color Change Spews additional after color clear In forum Print tips (Archive)	před 7 years
	Thanks Aaron for the explanation. I had not accounted for th... In forum Improvements (Archive)	před 7 years
	Thanks for pointing me in the right direction on how to make... In forum Improvements (Archive)	před 7 years
	Colorprint Color Change Layer counterintuitive In forum Improvements (Archive)	před 7 years
	Begin print cycle time reduction - calibrate while heating In forum Improvements (Archive)	před 7 years
	Supports...what happened here? In forum Print tips (Archive)	před 7 years
	Found a better way to adjust x y skew In forum Prusa i3 kit (Archive)	před 7 years
	Thanks for taking the time to reply Panos. The fit of the ... In forum Others (Archive)	před 7 years
	Bed skewed causes/fixes? In forum Others (Archive)	před 7 years

Fórum Statistiky

559 Fóra

62.3 K Témata

440 K Příspěvky

19 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed