Prusa3D Forum

Notifications

Clear all

ceceppa

Skupina: Registrovaný

Přidal se: 2020/09/15

Active Member

	The filament does feel different from all the other PLA I ha... In forum Assembly and first prints troubleshooting	před 5 years
	I've managed to have three successful print, this is the las... In forum Assembly and first prints troubleshooting	před 5 years
	Thanks all for the reply @gkmakeit I've tried at 210 and 220... In forum Assembly and first prints troubleshooting	před 5 years
	@gkmakeit Do you have a way to check the diameter of the fil... In forum Assembly and first prints troubleshooting	před 5 years
	Issue with Filamentum Crystal Clear In forum Assembly and first prints troubleshooting	před 5 years
	Thanks all for the reply. I've contacted the support again a... In forum Assembly and first prints troubleshooting	před 5 years
	Thanks, @joantabb, I've actually managed to lower the PINDA ... In forum Assembly and first prints troubleshooting	před 5 years
	Hi, thanks for the reply. I did check with the support and t... In forum Assembly and first prints troubleshooting	před 5 years
	XYZ calibration failed - Calibration Z issue In forum Assembly and first prints troubleshooting	před 5 years
	Hi, I'm very new to 3d print, but I've had some similar issu... In forum Assembly and first prints troubleshooting	před 5 years
	@bobstro Thanks for the suggestion. Before printing Benchy a... In forum Assembly and first prints troubleshooting	před 5 years
	First 3d printer and my 1st Benchy. In forum Assembly and first prints troubleshooting	před 5 years

Fórum Statistiky

585 Fóra

68 K Témata

476.4 K Příspěvky

9 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed