|
The filament does feel different from all the other PLA I ha... In forum Assembly and first prints troubleshooting |
4 years ago |
|
I've managed to have three successful print, this is the las... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Thanks all for the reply @gkmakeit I've tried at 210 and 220... In forum Assembly and first prints troubleshooting |
4 years ago |
|
@gkmakeit Do you have a way to check the diameter of the fil... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Issue with Filamentum Crystal Clear In forum Assembly and first prints troubleshooting |
4 years ago |
|
Thanks all for the reply. I've contacted the support again a... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Thanks, @joantabb, I've actually managed to lower the PINDA ... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Hi, thanks for the reply. I did check with the support and t... In forum Assembly and first prints troubleshooting |
5 years ago |
|
XYZ calibration failed - Calibration Z issue In forum Assembly and first prints troubleshooting |
5 years ago |
|
Hi, I'm very new to 3d print, but I've had some similar issu... In forum Assembly and first prints troubleshooting |
5 years ago |
|
@bobstro Thanks for the suggestion. Before printing Benchy a... In forum Assembly and first prints troubleshooting |
5 years ago |
|
First 3d printer and my 1st Benchy. In forum Assembly and first prints troubleshooting |
5 years ago |
