Prusa3D Forum

Notifications

Clear all

Carsten

Groupe: Enregistré

A(ont) rejoint: 2016/11/02

Estimable Member

	I checked again. I looked more at failed things which obviou... Dans le forum Hardware, firmware and software help	il y a 3 years
	Ok. Maybe I try lower values. I even put the pieces under a ... Dans le forum Hardware, firmware and software help	il y a 3 years
	I think I had that too. I deleted it in the printer. Carsten Dans le forum Hardware, firmware and software help	il y a 3 years
	SL1: (not S!) Is the calibration print function working?! Dans le forum Hardware, firmware and software help	il y a 3 years
	Stefan used PP on the Prusa: Cheers, Carsten Dans le forum How do I print this? (Printing help)	il y a 6 years
	Raspi Zero Handheld Console Jo approved 🙂 Dans le forum Awesome prints (Hall Of Fame)	il y a 7 years
	I printed TPU successfully (albeit slow...) with my Original... Dans le forum Print tips (Archive)	il y a 7 years
	Wow! Very nice processing. I LOVE the patina effect, just wi... Dans le forum Awesome prints (Hall Of Fame)	il y a 7 years
	Well I just digged a bit into the problem. The original log... Dans le forum Hardware, firmware and software help	il y a 7 years
	I can't help just that I never got a half decent layer first... Dans le forum Hardware, firmware and software help	il y a 7 years
	Print time on LCD after FW update to 3.1.0 gone? Dans le forum Others (Archive)	il y a 7 years
	Excuse me if it was already asked: Did slic3r report any er... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Then the overhang is just too steep. Have a look at this (cr... Dans le forum Others (Archive)	il y a 7 years
	The S update would make it more complete: Upgrade kit cont... Dans le forum Others (Archive)	il y a 7 years
	The slow shifting would let me look at the motor pulleys. Ch... Dans le forum Others (Archive)	il y a 7 years
	Try reorient your part so that the sharpes overhang is point... Dans le forum Others (Archive)	il y a 7 years
	Upgrade Package price and content... Dans le forum Others (Archive)	il y a 7 years
	Ups, yes. Better in 1.36. Remark to myself: NEVER name a ic... Dans le forum Print tips (Archive)	il y a 7 years
	It is not working for me. In my case I think that slic3r is ... Dans le forum Print tips (Archive)	il y a 7 years
	Before start; ; PID tuning M301 P15.27 I0.98 D59.42 ;bee... Dans le forum Software (Archive)	il y a 7 years

Page 1 / 8 Suivant

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

21 En-ligne

68.1 K Membres

Le dernier des messages: Prusa Core One - Intial thoughts...... Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé