Prusa3D Forum

Notifications

Clear all

CalebLA

Skupina: Registrovaný

Přidal se: 2022/03/13

Active Member

	Great suggestion! Print with height range modifier Print w... In forum How do I print this? (Printing help)	před 2 years
	Not sure why they are not coming through, but let me try a l... In forum How do I print this? (Printing help)	před 2 years
	Prints Caving Slightly after Adding Height Range Modifier In forum How do I print this? (Printing help)	před 2 years
	What are the advantages of a dual drive extruder? I haven't ... In forum How do I print this? (Printing help)	před 2 years
	Thanks for all the replies! I do have a filament run-out sen... In forum How do I print this? (Printing help)	před 2 years
	Filament Snapping in Extruder In forum How do I print this? (Printing help)	před 2 years
	Maybe time for Prusa Tech support...😀! In forum How do I print this? (Printing help)	před 3 years
	Help Please! Bed STILL not level, even after I tried everyth... In forum How do I print this? (Printing help)	před 3 years
	Thanks for the reply! Could the printer being on an unlevel ... In forum How do I print this? (Printing help)	před 3 years
	Thanks for all the replies! Not sure if I should have replie... In forum How do I print this? (Printing help)	před 3 years
	Thanks for all the replies! Not sure if I should have repl... In forum How do I print this? (Printing help)	před 3 years
	I just checked my printer, and yes, it seems like the X-carr... In forum How do I print this? (Printing help)	před 3 years
	Bed Not level, after performed 1st Layer calibration In forum How do I print this? (Printing help)	před 3 years
	Thanks for the reply! Do you think maybe the extruder gear n... In forum How do I print this? (Printing help)	před 3 years
	One thing I forgot to mention: It had been printing fine for... In forum How do I print this? (Printing help)	před 3 years
	Thanks for all the replies! It was very helpful! Thanks agai... In forum How do I print this? (Printing help)	před 3 years
	Brittle Parts on One Side of Bed but Extremely Strong on oth... In forum How do I print this? (Printing help)	před 3 years
	Unable Perform First Layer Calibration Lower than -2.000 mm In forum How do I print this? (Printing help)	před 3 years

Fórum Statistiky

565 Fóra

63.7 K Témata

446.7 K Příspěvky

19 Online

69.2 K Uživatelé

Poslední Příspěvek: First layer is too low MK4S Nový Uživatel: Anonymous Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed