Notifications
Clear all
byhova
byhova
Skupina: Registrovaný
Přidal se: 2019/09/17
Active Member
1
So I raised the temp 5 degrees, put in new filament. It prin...

In forum Hardware, firmware and software help

před 2 months
Thanks for the reply. I went ahead and put on a new spool of...

In forum Hardware, firmware and software help

před 2 months
All of my prints serarate or layers do not adhere very well ...

In forum Hardware, firmware and software help

před 2 months
I think I found the problem. When I got home yesterday the l...

In forum Hardware, firmware and software help

před 3 years
If so I don’t know how as I didn’t make any changes other th...

In forum Hardware, firmware and software help

před 3 years
I can check the speed thing you described when I get home fr...

In forum Hardware, firmware and software help

před 3 years
Sorry I wasn’t more clear. No all I am doing is after the ob...

In forum Hardware, firmware and software help

před 3 years
Print times keeps extending each Print

In forum Hardware, firmware and software help

před 3 years
@karl-herbert I will check when I get home but it would be h...

In forum Hardware, firmware and software help

před 5 years
@joantabb No I haven't. Do I need to disassemble the X-axis ...

In forum Hardware, firmware and software help

před 5 years
Crash Detection on my X-Axis on my MK3S

In forum Hardware, firmware and software help

před 5 years
@david-a66 So what would cause that & how would I fix th...

In forum Hardware, firmware and software help

před 5 years
Changing filament help.

In forum Hardware, firmware and software help

před 5 years
Share: