Notifications
Clear all
Busy With 3D Printing
Busy With 3D Printing
Group: Registered
Joined: 2023/08/14
Eminent Member
2
Finally! 😃

In forum General discussion, announcements and releases

3 months ago
RE: 3.9 to 3.9s

In forum General discussion, announcements and releases

3 months ago
Suffering from under extrusion ( thankfully fixed )

In forum Awesome prints (Hall Of Fame)

4 months ago
Probably the worst one I have ever seen.

In forum Awesome prints (Hall Of Fame)

4 months ago
I feel like Prusa is a good company, it's just some people w...

In forum General discussion, announcements and releases

4 months ago
I am also struggling with this issue, and was forced to use ...

In forum Input Shaper (MINI)

4 months ago
[Poll] What do you think on PrusaSlicer 2.8.0?

In forum PrusaSlicer

4 months ago
Not really

In forum Input Shaper (MINI)

4 months ago
When is the next major firmware update?

In forum General discussion, announcements and releases

5 months ago
You could just disable the wipe tower.

In forum General discussion, announcements and releases

5 months ago
PrusaSlicer to PrusaConnect Issue

In forum Bugs & Errors

9 months ago
Of course!

In forum General discussion & User Experience & Ideas

9 months ago
Feature Request - Built-in calculator on PrusaConnect

In forum General discussion & User Experience & Ideas

9 months ago
Ability to move b/gcodes to a folder in PrusaConnect

In forum General discussion & User Experience & Ideas

9 months ago
That is a feature that doesn't sound like a lot, but actuall...

In forum General discussion & User Experience & Ideas

10 months ago
Well, if you notice in the video on the Prusa Enclosure, at ...

In forum General discussion, announcements and releases

11 months ago
It's because 0.25 mm layer height is so thick that Input Sha...

In forum Input Shaper (MINI)

11 months ago
This is the firmware I've been waiting for!

In forum Input Shaper (MINI)

11 months ago
What is Connect Files?

In forum Introduction & Instructions

12 months ago
RE: Hall of Shame

In forum Awesome prints (Hall Of Fame)

12 months ago
Page 1 / 2
Share: