Prusa3D Forum

Notifications

Clear all

btrout

Group: Registered

Joined: 2022/01/29

Active Member

	Just before I lubricated the rods, they felt dry to the touc... In forum Hardware, firmware and software help	2 years ago
	Make sure your X, Y, and Z rods are clean and Lubricated. M... In forum Hardware, firmware and software help	2 years ago
	I just cleaned the rods and lubricated them. I did not touc... In forum Hardware, firmware and software help	2 years ago
	I'm still a newbie, but was reading this thread just to see ... In forum Hardware, firmware and software help	2 years ago
	RandyM9, Thank you. This is my first 3D printer and I built... In forum Hardware, firmware and software help	2 years ago
	One Reason for "Crash Detected" during MESH Bed Leveling - L... In forum Hardware, firmware and software help	2 years ago
	Communication Error (Resolved) - Octopi Communication Error In forum User mods - OctoPrint, enclosures, nozzles, ...	3 years ago
	Swiss_Cheese, Alrighty then. Thank you for the info. Bob In forum PrusaSlicer	3 years ago
	Sequential Printing and Arranging Multiple Instances In forum PrusaSlicer	3 years ago

Forum Statistics

565 Forums

63.7 K Topics

446.7 K Posts

21 Online

69.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed