Prusa3D Forum

Notifications

Clear all

bsannicolas

Groupe: Enregistré

A(ont) rejoint: 2023/12/11

Active Member

	Yes, using the Use the Configuration>Check for configurat... Dans le forum Hardware, firmware and software help	il y a 2 years
	Just passed the x axis test! The belt was too loose. I had t... Dans le forum Hardware, firmware and software help	il y a 5 years
	After firmware updates, the x axis has still been failing. A... Dans le forum Hardware, firmware and software help	il y a 5 years
	Looks like a firmware update will resolve this issue in 4.3.... Dans le forum Hardware, firmware and software help	il y a 5 years
	I had the same unusual results as the video in this post I'... Dans le forum Hardware, firmware and software help	il y a 5 years
	Some commented that they resolved it by reconfiguring the ha... Dans le forum Hardware, firmware and software help	il y a 5 years
	I downgraded to 4.2.1 with supports help. All self tests wer... Dans le forum Hardware, firmware and software help	il y a 5 years
	After 4.3.0 firmware updates, self test XYZ axis always fail... Dans le forum Hardware, firmware and software help	il y a 5 years

Statistiques du forum

598 Forums

71.8 K Sujets

504.1 K Messages

11 En-ligne

83.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé