Prusa3D Forum

Notifications

Clear all

bryan.j5

Group: Registered

Joined: 2017/12/04

Active Member

	Another thing to try is hook the printer up to a laptop whil... In forum Others (Archive)	7 years ago
	I was talking about the failure stats. Thinking perhaps ther... In forum Others (Archive)	7 years ago
	Mine squeaks just a bit when retracting. It doesn't bother m... In forum Others (Archive)	7 years ago
	Might also be a bad SD card. You might try using a different... In forum Others (Archive)	7 years ago
	Sounds a lot like a gcode file that is truncated. Try downlo... In forum Others (Archive)	7 years ago
	I guess the folks in the Prusa factory would have the best i... In forum Others (Archive)	7 years ago
	Check the basics first. Is it extruding the correct length... In forum Others (Archive)	7 years ago
	Have you tried any of the included Gcode files? When I'm tro... In forum Others (Archive)	7 years ago
	I have the same issue. Running the latest firmware (b150). I... In forum Others (Archive)	7 years ago
	Layer shift after power panic (b150) In forum Prusa i3 kit (Archive)	7 years ago
	Most of the sections are assembled separately before adding ... In forum Others (Archive)	7 years ago

Forum Statistics

559 Forums

63 K Topics

443.6 K Posts

19 Online

67.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed