|
A smaller amount of RMS surface deviation reveals the line a... In forum Hardware, firmware and software help |
5 hours ago |
|
Might be a coincidence, but the ring defect mimics (roughly)... In forum Hardware, firmware and software help |
1 day ago |
|
Might be a coincidence, but the ring defect mimics (roughly)... In forum Hardware, firmware and software help |
1 day ago |
|
I can report that using a 2mm radius fillet at the base didn... In forum Hardware, firmware and software help |
2 days ago |
|
For any filament, do not trust that it will be dry out of th... In forum General discussion, announcements and releases |
2 days ago |
|
I haven't noticed any feeding issues. Don't think the Bowde... In forum Hardware, firmware and software help |
2 days ago |
|
I can put in a fillet of 2mm easily on the bottom piece. Th... In forum Hardware, firmware and software help |
2 days ago |
|
If anything, I'm slightly under extruding, at least for 0.2m... In forum Hardware, firmware and software help |
2 days ago |
|
Yes, I can make a filleted transition in the bottom, rather ... In forum Hardware, firmware and software help |
2 days ago |
|
Heavy handed, yes, but simple to implement. Yes, this is a ... In forum Hardware, firmware and software help |
2 days ago |
|
@hyiger, In this particular case, I could find the layer and... In forum Hardware, firmware and software help |
2 days ago |
|
From my quick look, there is no real solution to the benchy ... In forum Hardware, firmware and software help |
2 days ago |
|
@hyiger Just so I understand, changing the fan like that wil... In forum Hardware, firmware and software help |
2 days ago |
|
Here's the link to both 3mf files for the top and bottom. ... In forum Hardware, firmware and software help |
3 days ago |
|
I made a simple cylinder with a pocket, and although I can s... In forum Hardware, firmware and software help |
3 days ago |
|
Yes, but the zipped file is 11.8MB, or nearly 20% greater th... In forum Hardware, firmware and software help |
3 days ago |
|
Hmm, even compressed it is over 10MB. Heck, the zip file is... In forum Hardware, firmware and software help |
3 days ago |
|
Pardon my inexperience, do I have to zip the 3mf file? Or j... In forum Hardware, firmware and software help |
3 days ago |
|
Here's a picture. Not the greatest, but shows the dual line... In forum Hardware, firmware and software help |
3 days ago |
|
Fine horizontal lines on exterior when an internal feature e... In forum Hardware, firmware and software help |
3 days ago |
