Notifications
Clear all
bretcobrageek
Group: Registered
Joined: 2018/01/25
Active Member
1
| I've had an installation of octopi running for a long time o... | 5 years ago | |
| Thanks for the help understanding the prusaprint vs. octopi.... | 7 years ago | |
| That's been my issue as well. The only descriptions are for... | 7 years ago | |
| Prusaprint vs. latest Octoprint | 7 years ago | |
| I think I pinned down the problem. I was downloading the ne... | 7 years ago | |
| Firmware 3.2.0 Released! | 7 years ago | |
| Excellent points Sean. Thanks for the 75C max temp suggesti... | 7 years ago | |
| The filament alignment is good, but after fighting the first... | 7 years ago | |
| Heatsink for Extruder motor? | 7 years ago |