Čeština
Fóra
Uživatelé
boomboom21
Aktivita
 
Notifications
Clear all
boomboom21
boomboom21
Skupina: Registrovaný
Přidal se: 2016/11/05
Active Member
1
Profile Aktivita
Very cool. Have you had any problems not using a buffer? D...

In forum General discussion, announcements and releases

 před 2 months
I thought the gcode "fix" was working but still having issue...

In forum Hardware, firmware and software help

 před 3 months
Support told me it's a known bug and a fix is coming. Worka...

In forum Hardware, firmware and software help

 před 3 months
You don't need to reprint the piece with the festo (I didn't...

In forum Assembly and first prints troubleshooting

 před 6 years
I had same problem. The IR sensor was primarily stuck on 0....

In forum Assembly and first prints troubleshooting

 před 6 years
I initially printed the MK3S/MMU2S upgrade parts in black eS...

In forum Assembly and first prints troubleshooting

 před 6 years
I'm having same problem. Resetting MMU2 didn't help. I con...

In forum Assembly and first prints troubleshooting

 před 6 years
Support sent me a new power supply. Replacement still has t...

In forum Hardware, firmware and software help

 před 8 years
Since disabling filament sensor and crash detection I haven'...

In forum General discussion, announcements and releases

 před 8 years
Since disabling filament sensor and crash detection I haven'...

In forum General discussion, announcements and releases

 před 8 years
I discovered today that my heatbed thermostat wire had too m...

In forum Others (Archive)

 před 8 years
Same thing happened again this morning. I was able to gr...

In forum Others (Archive)

 před 8 years
Failed print - XYZ motors appear stopped, filament still ext...

In forum Others (Archive)

 před 8 years
I had a layer shift happen today. If I look in the stats it...

In forum Others (Archive)

 před 8 years
Ditto....same PSU clicking noise.

In forum Hardware, firmware and software help

 před 8 years
Share: