Notifications
Clear all
BoilermakerFan
Skupina: Registrovaný
Přidal se: 2018/03/22
Active Member
1
| I've since tried installing older firmware versions and tryi... | před 5 years | |
| Installed MK2.5S Upgrade - Now it fails calibration - I've t... | před 5 years | |
|
Here's mine printed at 0.15mm Optimal without supports, 5mm ... In forum Print tips (Archive) |
před 7 years | |
|
Hi BMF, Yes I did use Supports
they came off reasonably ea... In forum Print tips (Archive) |
před 7 years | |
|
Nice! Did you use supports?
I'm getting ready to mod the f... In forum Print tips (Archive) |
před 7 years | |
|
in Slic3r, load the model,
scale to 600%
slice and look at y... In forum Print tips (Archive) |
před 7 years | |
|
How do I remove the first layer of a model to make the seco... In forum Print tips (Archive) |
před 7 years |