Prusa3D Forum

Notifications

Clear all

bofhdk

Grupa: Zarejestrowany

Dołączył: 2023/02/24

Active Member

	Ahh, thanks :)I was kind of hoping for something less involv... In forum Hardware, firmware and software help	2 years temu
	Is there any way I could use the unused Therm1 socket instea... In forum Hardware, firmware and software help	2 years temu
	I've decided to order a new board (rev 1.1b is all that's av... In forum Hardware, firmware and software help	2 years temu
	I've just tried unplugging everything other than the hot-end... In forum Hardware, firmware and software help	2 years temu
	Ahh - ok - thanks for the update 🙂 .........but......does... In forum Hardware, firmware and software help	2 years temu
	Ah - sorry - not the display i posted, the 0/0 and 24/0 - i... In forum Hardware, firmware and software help	2 years temu
	The printer is a couple of years old. I bought it from a fri... In forum Hardware, firmware and software help	2 years temu
	The hot-end temps are 0/0 and the bed is 24/0 (24=ambient).... In forum Hardware, firmware and software help	2 years temu
	"ERR: MINTEMP", not loose wires, possibly the EINSY(?) board... In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.7 K Posty

21 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte