|
Thanks for your very swift reply, it worked a treat, no issu... In forum Hardware, firmware and software help |
2 days temu |
|
Mk4 to Core one upgrade In forum Hardware, firmware and software help |
2 days temu |
|
Thanks for that, yes I'm going to contact Prusa when I get t... In forum Hardware, firmware and software help |
2 weeks temu |
|
I'm not sure what happened there but I pasted the contents o... In forum Hardware, firmware and software help |
2 weeks temu |
|
Hi, I finally got the input port error again, picture attach... In forum Hardware, firmware and software help |
2 weeks temu |
|
Hi, Just an update, I just turned the Core One on and I got ... In forum Hardware, firmware and software help |
2 weeks temu |
|
I can only get a picture if and when it happens again, I wil... In forum Hardware, firmware and software help |
2 weeks temu |
|
Prusa core one input port overcurrent error In forum Hardware, firmware and software help |
2 weeks temu |
|
Yes, I have never had to input the type of filament before t... In forum Hardware, firmware and software help |
1 month temu |
|
Yes, that is a way of doing it but after this firmware updat... In forum Hardware, firmware and software help |
1 month temu |
|
Most of my prints are four or five colours and I sometimes o... In forum Hardware, firmware and software help |
1 month temu |
|
Thanks for replying, hopefully if enough people complain we ... In forum Hardware, firmware and software help |
1 month temu |
|
Firmware update 6.5.3 In forum Hardware, firmware and software help |
1 month temu |
|
No broken filament or debris triggering the sensor, did a fi... In forum Hardware, firmware and software help |
1 month temu |
|
Hi, thanks for your reply but as the print starts and comple... In forum Hardware, firmware and software help |
1 month temu |
|
Latest Firmware Update 6.5.3 Core One In forum Hardware, firmware and software help |
2 months temu |
|
MMU3 In forum PrusaSlicer |
5 months temu |
|
Hi, thanks for your reply and solution, something so simple ... In forum PrusaSlicer |
5 months temu |
|
Thanks for that, I will have a look at it in the morning and... In forum PrusaSlicer |
5 months temu |
|
I print it upside down as the top is the flat surface and th... In forum PrusaSlicer |
5 months temu |
