Notifications
Clear all
bnjmn83
bnjmn83
Skupina: Registrovaný
Přidal se: 2017/04/17
Eminent Member
2
PETG Temperature Tower leaving bumps on surface

In forum How do I print this? (Printing help)

před 6 years
How can i specifiy a noozle temperature change for sequentia...

In forum General discussion, announcements and releases

před 6 years
To me something similar happened today. Not sure what it ca...

In forum Others (Archive)

před 7 years
So I re-did the filament and feeding calibration and the res...

In forum Others (Archive)

před 7 years
Yes this could be one way to go. But the shape needs to enfo...

In forum Others (Archive)

před 7 years
Thx for the advice. I could do a quick test with 0.35 mm and...

In forum Others (Archive)

před 7 years
Here a comparison between both prints and my sprinting speed...

In forum Others (Archive)

před 7 years
Sorry for the late reply. I finally got the time to redo the...

In forum Others (Archive)

před 7 years
Poor PLA print Quality; Need some advice on what to improve.

In forum Others (Archive)

před 7 years
Can one make an assumption of the state of my printer regard...

In forum Print tips (Archive)

před 7 years
I have finished the square calibration prints from Jeff: -0...

In forum Print tips (Archive)

před 7 years
if you've read at least the first 4 sites of my thread, you ...

In forum Print tips (Archive)

před 7 years
if you've read at least the first 4 sites of my thread, you ...

In forum Print tips (Archive)

před 7 years
2) Make sure PINDA is above nozzle tip by <1mm but above ...

In forum Print tips (Archive)

před 7 years
here a first result on the square calibration by jeff: -672...

In forum Print tips (Archive)

před 7 years
Thanks guys I will get to it asap. I have additionally print...

In forum Print tips (Archive)

před 7 years
So the top layer fill made a difference. But as you can see ...

In forum Print tips (Archive)

před 7 years
Bad top layer

In forum Print tips (Archive)

před 7 years
just received an email which confirmed the defect and a new ...

In forum Prusa i3 kit (Archive)

před 7 years
If this is the right schematic I don't think these both pins...

In forum Prusa i3 kit (Archive)

před 7 years
Stránka 1 / 2
Share: