Notifications
Clear all
bjarne.b
Skupina: Registrovaný
Přidal se: 2017/01/22
Active Member
1
|
I found the problem with the really bad prints. It was Slic3... In forum Print tips (Archive) |
před 8 years | |
|
Here is the first layer of Batman. The treefrog prints ok, I... In forum Print tips (Archive) |
před 8 years | |
|
All prints are set up with temperature for PLA (215). Only b... In forum Print tips (Archive) |
před 8 years | |
|
I have Slic3r Prusa Edition ver.: 1.33.8-Prusa3d. On two of... In forum Print tips (Archive) |
před 8 years | |
|
Newbie print problems In forum Print tips (Archive) |
před 8 years | |
|
My first test after working with building the Prusa almost a... In forum Prusa i3 kit (Archive) |
před 8 years |