Notifications
Clear all
bizilux
bizilux
Group: Registered
Joined: 2019/09/16
Active Member
1
okay, I ordered the silicone socks, so I suppose I will suck...

In forum PrusaSlicer

5 years ago
yeh i did see that suggestion before... but in the meantime ...

In forum PrusaSlicer

5 years ago
How to configure nozzle fan to start up slowly and not full ...

In forum PrusaSlicer

5 years ago
biggerandwifibut we can talk all day and all night, and it w...

In forum General discussion, announcements and releases

5 years ago
you are right, I didn't even think 0.07x10 is not that much ...

In forum How do I print this? (Printing help)

5 years ago
@tim-m30 which hex pattern infill do you mean? honeycomb? I ...

In forum How do I print this? (Printing help)

5 years ago
everything except for crossing perimeters is enabled already...

In forum How do I print this? (Printing help)

5 years ago
what are your top and bottom layers set to? That is what im ...

In forum How do I print this? (Printing help)

5 years ago
well this does look good... problem is my old 3B died on me....

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
so yeh, the test was a fail or success, depending on if you ...

In forum How do I print this? (Printing help)

5 years ago
yes, that would probably work out better, but you used prope...

In forum How do I print this? (Printing help)

5 years ago
Okay, my reply is approved now, so check post #3 for proper ...

In forum How do I print this? (Printing help)

5 years ago
sadly my account is new, so my long reply with pictures and ...

In forum How do I print this? (Printing help)

5 years ago
@tim-m30 thanks for your input!the thing is, that grittiness...

In forum How do I print this? (Printing help)

5 years ago
How do i print Hyperbolic Funnel? (VERY high overhang angle ...

In forum How do I print this? (Printing help)

5 years ago
Share: