Notifications
Clear all
BINGOBRICKS
Skupina: Registrovaný
Přidal se: 2019/07/08
Active Member
1
|
I've had the same problem since upgrading to MK4s. Before, w... In forum Hardware, firmware and software help |
před 8 months | |
| Flex (TPU) mit 0.25mm Düse | před 5 years | |
|
thanks for that until now. very valuable information! There ... In forum Hardware, firmware and software help |
před 6 years | |
|
Reducing current on extruder motor In forum Hardware, firmware and software help |
před 6 years | |
| The silver filament that comes with the printer is just "Pru... | před 6 years | |
|
Printing directly from Slicer without Pronterface In forum Hardware, firmware and software help |
před 6 years | |
|
MK3s - Tension on extruder idler In forum Hardware, firmware and software help |
před 6 years |