Prusa3D Forum

Notifications

Clear all

Bill2020

Groupe: Enregistré

A(ont) rejoint: 2020/11/21

Active Member

	Never mind, I tried an Ethernet Connection, and it worked im... Dans le forum Hardware, firmware and software help	il y a 2 years
	MK3,5 Prusa Connect - Connection Refused Dans le forum Hardware, firmware and software help	il y a 2 years
	I tested with the Glue Stick that Prusa included with the MK... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@mrstoned Sure, but how about on the Prusa MK3S with the tex... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Of the large images, top one standing, bottom one laying fla... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@koyo Thanks for the feedback and suggestions Koyo! Very int... Dans le forum How do I print this? (Printing help)	il y a 5 years
	While lithos can be printed flat as you describe, and I have... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Lithophanes on MK3S+ on the Textured PEI Powder Coated Sheet Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

585 Forums

67.9 K Sujets

475.9 K Messages

12 En-ligne

75.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé