Prusa3D Forum

Notifications

Clear all

bill2009

Groupe: Enregistré

A(ont) rejoint: 2022/04/22

Eminent Member

	ok that's helpful. i'll try it later today. Dans le forum PrusaSlicer	il y a 2 months
	Octoprint on new Slicer Install Dans le forum PrusaSlicer	il y a 2 months
	Questions about loading negative volume Dans le forum PrusaSlicer	il y a 3 months
	Thanks for the replies. after googling around a bit i tried... Dans le forum Hardware, firmware and software help	il y a 5 months
	Thanks. I've verified i have a single bbf file on a freshly... Dans le forum Hardware, firmware and software help	il y a 5 months
	How To Install Firmware? Dans le forum Hardware, firmware and software help	il y a 5 months
	it was in fact the binary gcode issue. my printer profile h... Dans le forum Hardware, firmware and software help	il y a 12 months
	suddenly getting errors Dans le forum Hardware, firmware and software help	il y a 12 months
	hi: if i want to switch to a .25 nozzle and scale it down to... Dans le forum How do I print this? (Printing help)	il y a 1 year
	yes, i'm really pleased with how it turned out. as you note... Dans le forum How do I print this? (Printing help)	il y a 1 year
	This is great. thanks very much for the settings. i'll mak... Dans le forum How do I print this? (Printing help)	il y a 1 year
	RE: Removing supports Dans le forum How do I print this? (Printing help)	il y a 1 year
	That’s quite a bit better. Thanks very much. I’ll look at yo... Dans le forum How do I print this? (Printing help)	il y a 1 year
	thanks very much. I can import the 3mf as a project and the... Dans le forum How do I print this? (Printing help)	il y a 1 year
	trying again da7a2f92-l_body_new.zip Dans le forum How do I print this? (Printing help)	il y a 1 year
	Removing supports Dans le forum How do I print this? (Printing help)	il y a 1 year
	@Fuchsr:That's exactly what i needed - thanks a lot! Dans le forum How do I print this? (Printing help)	il y a 2 years
	ok thanks - i'll order them today. Dans le forum Hardware, firmware and software help	il y a 2 years
	Printed Directly on Heatbed - is it ruined? Dans le forum Hardware, firmware and software help	il y a 2 years
	print only part of plate Dans le forum How do I print this? (Printing help)	il y a 2 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

22 En-ligne

68.9 K Membres

Le dernier des messages: Prusa Slicer Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé