Notifications
Clear all
bijlevel
Skupina: Registrovaný
Přidal se: 2021/09/01
Active Member
1
|
Thanks Dan! Will be too costly for me and I even don't know ... In forum Hardware, firmware and software help |
před 3 years | |
|
Is Prusa PETG absolutely needed or can Prusa PLA do the job?... In forum Hardware, firmware and software help |
před 3 years | |
|
Thanks Joan! In forum Hardware, firmware and software help |
před 3 years | |
|
Thank you! Not clear to me if it also can be used for MK2.5. In forum Hardware, firmware and software help |
před 3 years | |
|
@ point 2: where can I find this downloadable gcode? In forum Hardware, firmware and software help |
před 3 years | |
|
I have the same problem. Did you solve the issue? KR, Sjoerd In forum Hardware, firmware and software help |
před 3 years |