Actividad
 
Avisos
Vaciar todo
BernieC
BernieC
Grupo: Registrado
Registrado: 2018/09/01
Trusted Member
3
Quick question about the messaging stuff: does the "message...

En el foro General discussion, announcements and releases

hace 4 years
@robert-rmm200 Thanks -- I found the little "message" icon o...

En el foro General discussion, announcements and releases

hace 5 years
@robert-rmm200 I did that and it is enlightening. Thanks!! ...

En el foro General discussion, announcements and releases

hace 5 years
Mk3 Repair service in the US?

En el foro General discussion, announcements and releases

hace 5 years
@karl-herbert Thanks for the picture it helps a lot. I reme...

En el foro Hardware, firmware and software help

hace 5 years
@karl-herbert Thanks for the info. I hope it isn't the the...

En el foro Hardware, firmware and software help

hace 5 years
What I forgot to include is -- does anyone have a conjecture...

En el foro Hardware, firmware and software help

hace 5 years
Thermal runaway - now extruder won't heat

En el foro Hardware, firmware and software help

hace 5 years
Thanks -- I see that there's no program to go from .scad to ...

En el foro How do I print this? (Printing help)

hace 5 years
.scad files

En el foro How do I print this? (Printing help)

hace 5 years
@franskrau Hmm. I wonder how that happened. It was at z=0 ...

En el foro PrusaSlicer

hace 5 years
OK, I give. I've uploaded the STL file: Angled Cube

En el foro PrusaSlicer

hace 5 years
What's the deal -- "file type not allowed". It's just an ST...

En el foro PrusaSlicer

hace 5 years
Why can't this be sliced?

En el foro PrusaSlicer

hace 5 years
@tim-m30 I didn't see any of that weird stuff. Every overha...

En el foro Hardware, firmware and software help

hace 5 years
I've done some testing and discovered three things. 1) the P...

En el foro Hardware, firmware and software help

hace 5 years
Ah, I see I have the terminology backwards. I means overhan...

En el foro Hardware, firmware and software help

hace 5 years
I'm not sure the terminology is quite right, but I saw your ...

En el foro Hardware, firmware and software help

hace 5 years
I'm perplexed, too -- in my config it was 90 and insisted on...

En el foro Hardware, firmware and software help

hace 5 years
Prusaslicer setting for ONLY necessary supports

En el foro Hardware, firmware and software help

hace 5 years
Página 2 / 5
Compartir: