Polski
Fora
Członkowie
Ben
Aktywność
 
Notifications
Clear all
Ben
Ben
Grupa: Zarejestrowany
Dołączył: 2016/06/22
Reputable Member
5
Profil Aktywność
for the exact motors on the MK2 The ambient temperature is ...

In forum Others (Archive)

 10 years temu
Generating electricity with a Prusa Stepper motor?

In forum Others (Archive)

 10 years temu
Mines in an enclosure. No problems with prints now. Its perf...

In forum Others (Archive)

 10 years temu
Do all calibrations. Once done that should be all that is re...

In forum Others (Archive)

 10 years temu
Thats a good idea. 😉 I dont suppose you have the stl you ...

In forum Others (Archive)

 10 years temu
It is absolutely amazing that Prusa cannot post this on thei...

In forum Others (Archive)

 10 years temu
I went for this one They are not a print and fit though yo...

In forum Others (Archive)

 10 years temu
To be completely honest if you want new bearings I would pri...

In forum Others (Archive)

 10 years temu
I have some bits from the nuts and bolts if that helps. I wo...

In forum Others (Archive)

 10 years temu
I print ABS at 250 with 100 bed temp. it is perfect but you ...

In forum Others (Archive)

 10 years temu
Peter thank you that is spot on. I am going to be trying ano...

In forum Others (Archive)

 10 years temu
Thanks all and Aaron. I am still yet to make the jump. I am ...

In forum Software (Archive)

 10 years temu
To be completely honest this should be in the improvement se...

In forum Print tips (Archive)

 10 years temu
You may have some filament stuck in the hot end/ extruder bo...

In forum Prusa i3 kit (Archive)

 10 years temu
I do not think Prusa has had a custom made one. Most pinda p...

In forum Others (Archive)

 10 years temu
It should come out ok. Reading the guide you need to heat th...

In forum Others (Archive)

 10 years temu
So does no body know the answer to the question? What woul...

In forum Others (Archive)

 10 years temu
Aaron you are a legend. I need a bow smilies 🙂 Thank you...

In forum Software (Archive)

 10 years temu
Yes agree with 3delight. Need to keep the heat on it. I noti...

In forum Others (Archive)

 10 years temu
Is that the link above that you worked on?

In forum Software (Archive)

 10 years temu
Strona 12 / 16
Share: