Attività
 
Notifiche
Cancella tutti
ben.g16
ben.g16
Gruppo: Registrato
Registrato: 2018/07/18
Estimable Member
4
Turns out to be the software. After turning the unit on and...

Nel forum General discussion, announcements and releases

5 years fa
As you might be able to see, my object is rather complicated...

Nel forum Hardware, firmware and software help

5 years fa
support blocker not working

Nel forum Hardware, firmware and software help

5 years fa
I have never been able to get filament autoload to work. It...

Nel forum Hardware, firmware and software help

5 years fa
MK3 wont restart after filament outage

Nel forum Hardware, firmware and software help

5 years fa
Tim, Thanks for the info. Would you mind posting your Suppo...

Nel forum General discussion, announcements and releases

5 years fa
Thanks. I was looking only for a -S/Y tensioner update, not...

Nel forum Hardware, firmware and software help

5 years fa
Thanks. I was looking only for a -S/Y tensioner update, not...

Nel forum Hardware, firmware and software help

5 years fa
Unfortunately, I have the original MK3 with add on S upgrade...

Nel forum Hardware, firmware and software help

5 years fa
Can you point me to the Prusa site with the updated dwgs? I...

Nel forum Hardware, firmware and software help

5 years fa
I too have spent the better part of 6 months trying to get s...

Nel forum General discussion, announcements and releases

5 years fa
OK, it seems there are two mindsets for printing multiple ob...

Nel forum How do I print this? (Printing help)

5 years fa
After all the hassle and good advice, I finally found the cu...

Nel forum General discussion, announcements and releases

5 years fa
Pronterface was not included in my Prusa's "software & d...

Nel forum How do I print this? (Printing help)

5 years fa
Milo, It is true that PrusaSlicer allows you to set the ext...

Nel forum How do I print this? (Printing help)

5 years fa
I have three objects on the print bed. I want to print one ...

Nel forum How do I print this? (Printing help)

5 years fa
printing individual objects

Nel forum How do I print this? (Printing help)

5 years fa
Tim was right about the Z layer. I changed filament and sta...

Nel forum General discussion, announcements and releases

5 years fa
Result: The boundaries printed well at startup, but the fil...

Nel forum General discussion, announcements and releases

5 years fa
ONE year old. Dont have any grit residue. Remember, I have...

Nel forum General discussion, announcements and releases

5 years fa
Pagina 4 / 6
Condividi: