Activity
 
Notifications
Clear all
beau.m
beau.m
Group: Registered
Joined: 2017/12/28
Trusted Member
3
Z axis failing incredibly bad- think I'm sending back

In forum Others (Archive)

7 years ago
I received my MK3 yesterday. It was a pre-built unit and I ...

In forum Others (Archive)

7 years ago
Everyone IS NOT having issues. How many MK3 kits/assembled p...

In forum Others (Archive)

7 years ago
For those arguing that Prusa is supposed to push boundaries ...

In forum Others (Archive)

7 years ago
If it's firmware, then everyone would be having issues. Man...

In forum Others (Archive)

7 years ago
Well I guess I didn't do my research enough, so I'm basicall...

In forum Others (Archive)

7 years ago
I get it, your unit works, so please tell the hundreds of ot...

In forum Others (Archive)

7 years ago
If it's firmware, then everyone would be having issues. Man...

In forum Others (Archive)

7 years ago
If it's firmware, then everyone would be having issues. Man...

In forum Others (Archive)

7 years ago
tighten the idler bearings so it can spin freely but doesn't...

In forum General discussion, announcements and releases

7 years ago
I wonder if some of the print issues are due to using the wr...

In forum Others (Archive)

7 years ago
Last night my printer threw itself out of alignment so bad i...

In forum Others (Archive)

7 years ago
The MK3 is a great machine. A lot of the problems plaguing p...

In forum Others (Archive)

7 years ago
Just read this entire thread- Two days ago I finally got my...

In forum Others (Archive)

7 years ago
What is your secret? I have not got 1 good print since I rec...

In forum Others (Archive)

7 years ago
This has been my ongoing issue since I got my MK3, prints co...

In forum Others (Archive)

7 years ago
Thanks you guys- will report back Regarding the Oil- what t...

In forum Others (Archive)

7 years ago
Support does not help, and I've read other people having thi...

In forum Others (Archive)

7 years ago
Problem after problem, getting very frustrated- please help

In forum Others (Archive)

7 years ago
Hello- I got my printer less than a week ago now, and have h...

In forum Hardware, firmware and software help

7 years ago
Page 3 / 3
Share: