Prusa3D Forum

Notifications

Clear all

Groupe: Enregistré

A(ont) rejoint: 2026/02/20

Active Member

	I think the dryer is working properly. The grey PETG was dri... Dans le forum How do I print this? (Printing help)	il y a 1 month
	I will try. Thanks for the tip. Dans le forum How do I print this? (Printing help)	il y a 1 month
	I have done several tests after drying the PETG filament for... Dans le forum How do I print this? (Printing help)	il y a 1 month
	Thanks for all the tips. I will look into it and try your su... Dans le forum How do I print this? (Printing help)	il y a 1 month
	I will give your suggestion a try. I am rather new to 3D p... Dans le forum How do I print this? (Printing help)	il y a 1 month
	I usually store it in a vacuum-sealed bag with a couple of s... Dans le forum How do I print this? (Printing help)	il y a 1 month
	It's an active dryer. I use a Creality Space Pi Filament Dry... Dans le forum How do I print this? (Printing help)	il y a 1 month
	Yes, I have (and use while printing ) a filament dryer that ... Dans le forum How do I print this? (Printing help)	il y a 1 month
	Stringing and Print Defects With Prusament PETG Dans le forum How do I print this? (Printing help)	il y a 1 month
	It seems you may be correct. I am having a lot of issues wit... Dans le forum How do I print this? (Printing help)	il y a 1 month
	Hi, Yes, I actually did have "Avoid crossing perimeters" ena... Dans le forum How do I print this? (Printing help)	il y a 2 months
	Got used to using it for both PLA and PETG which are the onl... Dans le forum How do I print this? (Printing help)	il y a 2 months
	So I was able to print with Prusament PLA and the layer shif... Dans le forum How do I print this? (Printing help)	il y a 2 months
	1. Not sure. Printer arrived assembled. Not many hours of us... Dans le forum How do I print this? (Printing help)	il y a 2 months
	Forgot to mention: (B+C) objects were printed with 0.4 HF no... Dans le forum How do I print this? (Printing help)	il y a 2 months
	Huge Layer Shift (?) Problems With PETG On Prusa Core One + Dans le forum How do I print this? (Printing help)	il y a 2 months

Statistiques du forum

598 Forums

71.3 K Sujets

500.3 K Messages

12 En-ligne

82 K Membres

Le dernier des messages: Link lost #35331 (CORE One L) Notre nouveau membre: Rooki Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé