Notifications
Clear all
battincld
Skupina: Registrovaný
Přidal se: 2020/01/23
Active Member
1
|
Hairy Unloads In forum Print tips (Archive) |
před 6 years | |
| @neophyl I should have mentioned, I bought it pre-assembled.... | před 6 years | |
| how high can it print | před 6 years | |
| new printer crashes | před 6 years | |
|
It was the PSU t-nuts. Thanks for all the help everyone In forum Hardware, firmware and software help |
před 6 years | |
| S_Holder rods - where to buy? | před 6 years | |
|
The lube fixed it. I wouldn't have thought that the bed wou... In forum Hardware, firmware and software help |
před 6 years | |
|
Thanks for the link to the assembly instructions. That has ... In forum Hardware, firmware and software help |
před 6 years | |
|
I've had my MK3S since mid Feb and have been printing non st... In forum Hardware, firmware and software help |
před 6 years | |
|
@just3d Ah! I had 2 m3x14 (?) in the bottom of the box whe... In forum Hardware, firmware and software help |
před 6 years | |
|
What is this sound on unused mk3s In forum Hardware, firmware and software help |
před 6 years |