Prusa3D Forum

Notifications

Clear all

BarrittWorks

Groupe: Enregistré

A(ont) rejoint: 2021/11/27

Active Member

	How can we keep our custom filament shrinkage settings activ... Dans le forum Hardware, firmware and software help	il y a 8 months
	Exactly what I have done as well (bypassed side sensors, rep... Dans le forum Hardware, firmware and software help	il y a 8 months
	Would version 4 ("R4") be of any use? Here it is: ...never... Dans le forum General discussion, announcements and releases	il y a 8 months
	@chicken-2 I've been away from the forum for a bit and am ju... Dans le forum General discussion, announcements and releases	il y a 11 months
	@jochen-3 thanks for sharing the comparison video. Very help... Dans le forum General discussion, announcements and releases	il y a 2 years
	Exact length (height) of the XL side extrusions? Dans le forum General discussion, announcements and releases	il y a 2 years
	Yep, that trick is genius. I switched to some relatively har... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 3 years
	+1 (I just opened the forum to ask the same question.) Als... Dans le forum General discussion, announcements and releases	il y a 4 years

Statistiques du forum

585 Forums

68.3 K Sujets

478.2 K Messages

9 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé