Notifications
Clear all
bardiir
bardiir
Group: Registered
Joined: 2017/05/10
Eminent Member
2
This is probably the setscrew for the x-axis pulley. Just sc...

In forum Others (Archive)

7 years ago
With Prusa Support not beeing very happy about me wanting to...

In forum Others (Archive)

7 years ago
Could also be the cooling fan spinning up and cooling down t...

In forum Others (Archive)

7 years ago
Maybe try makeprintable.com?

In forum Others (Archive)

7 years ago
Have you reported this fault on GitHub? If no, do so and pr...

In forum Hardware, firmware and software help

7 years ago
Yeah I'm pretty sure about this. I asked prusa support in ch...

In forum Others (Archive)

7 years ago
Here are pictures from my measurement before removing the pr...

In forum Others (Archive)

7 years ago
I measured with and without printer, same behavior. With pri...

In forum Others (Archive)

7 years ago
My PSU is broken I guess...

In forum Others (Archive)

7 years ago
Definitely possible, but will introduce the space on the bot...

In forum Hardware, firmware and software help

7 years ago
Btw... I printed this and experimented with it. I found that...

In forum Hardware, firmware and software help

7 years ago
Printer died... any ideas?

In forum Others (Archive)

7 years ago
This looks great although I struggle getting STLs from Onsha...

In forum Hardware, firmware and software help

7 years ago
Perfect thanks

In forum Others (Archive)

7 years ago
Well at least I'm not the only one suffering. But you're men...

In forum Others (Archive)

7 years ago
I'm currently reprinting most of my printers parts and I've ...

In forum Others (Archive)

7 years ago
Could stuttering occur with the axis binding up? Does the Pr...

In forum Others (Archive)

7 years ago
X-Axis belt is not rubbing (anymore), also prints are perfec...

In forum Others (Archive)

7 years ago
Stuttering travel moves

In forum Others (Archive)

7 years ago
I'm sorry, I forgot to mention: The bed is still flat accord...

In forum Others (Archive)

7 years ago
Page 1 / 2
Share: