Prusa3D Forum

Notifications

Clear all

Bambus

Groupe: Enregistré

A(ont) rejoint: 2025/06/26

Active Member

	Well, ive got an update.i tried drying filament and everythi... Dans le forum Hardware, firmware and software help	il y a 2 weeks
	i saw a video from cnc kitchen about drying in the microwave... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	yeah, chamber was at around 33 with printhead on printing te... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	i actually just tried to dry my filament a tiny bit by setti... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	how hot is too hot though?id say 16-20°C in the room the pri... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	yeah, that makes sense. I just dont understand why it didnt ... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	bad overhangs on one side of print Dans le forum Hardware, firmware and software help	il y a 4 weeks
	I had the heattrap and hotend cables mixed up. user error, o... Dans le forum Hardware, firmware and software help	il y a 5 months
	kit, nozzle heater check error Dans le forum Hardware, firmware and software help	il y a 5 months

Statistiques du forum

595 Forums

68.8 K Sujets

481.7 K Messages

16 En-ligne

77.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé