Prusa3D Forum

Notifiche

Cancella tutti

Backfisch_in_3D

Gruppo: Registrato

Registrato: 2025/08/15

Active Member

	Also my printer now sometimes bluescreens on startup. It bee... Nel forum General discussion, announcements and releases	1 month fa
	This has also been the case even before installing 6.4.0-alp... Nel forum General discussion, announcements and releases	1 month fa
	If you have enabled the Expert mode in PrusaSlicer you can e... Nel forum Hardware, firmware and software help	2 months fa
	Both belts influence each other, there is no way around this... Nel forum Assembly and first prints troubleshooting	2 months fa
	My tape-measure measurements are roughly the same, but the g... Nel forum Hardware, firmware and software help	2 months fa
	I just tried re-tensioning to 98/92, and the gap this causes... Nel forum Hardware, firmware and software help	2 months fa
	Aha! That makes more sense! Didnt think that the belt length... Nel forum Hardware, firmware and software help	2 months fa
	New belt tuning frequencies (98 / 92 Hz) - Discussion (is it... Nel forum Hardware, firmware and software help	2 months fa

Statistiche Forum

585 Forum

68.6 K Discussioni

480.2 K Post

11 Online

77 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso