Prusa3D Forum

Notifications

Clear all

Backfisch_in_3D

Groupe: Enregistré

A(ont) rejoint: 2025/08/15

Active Member

	Also my printer now sometimes bluescreens on startup. It bee... Dans le forum General discussion, announcements and releases	il y a 1 month
	This has also been the case even before installing 6.4.0-alp... Dans le forum General discussion, announcements and releases	il y a 1 month
	If you have enabled the Expert mode in PrusaSlicer you can e... Dans le forum Hardware, firmware and software help	il y a 2 months
	Both belts influence each other, there is no way around this... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	My tape-measure measurements are roughly the same, but the g... Dans le forum Hardware, firmware and software help	il y a 2 months
	I just tried re-tensioning to 98/92, and the gap this causes... Dans le forum Hardware, firmware and software help	il y a 2 months
	Aha! That makes more sense! Didnt think that the belt length... Dans le forum Hardware, firmware and software help	il y a 2 months
	New belt tuning frequencies (98 / 92 Hz) - Discussion (is it... Dans le forum Hardware, firmware and software help	il y a 2 months

Statistiques du forum

585 Forums

68.6 K Sujets

480.2 K Messages

11 En-ligne

77 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé