Avisos
Vaciar todo
Backfisch_in_3D
Grupo: Registrado
Registrado: 2025/08/15
Active Member
1
| Also my printer now sometimes bluescreens on startup. It bee... | hace 1 month | |
| This has also been the case even before installing 6.4.0-alp... | hace 1 month | |
|
If you have enabled the Expert mode in PrusaSlicer you can e... En el foro Hardware, firmware and software help |
hace 2 months | |
|
Both belts influence each other, there is no way around this... En el foro Assembly and first prints troubleshooting |
hace 2 months | |
|
My tape-measure measurements are roughly the same, but the g... En el foro Hardware, firmware and software help |
hace 2 months | |
|
I just tried re-tensioning to 98/92, and the gap this causes... En el foro Hardware, firmware and software help |
hace 2 months | |
|
Aha! That makes more sense! Didnt think that the belt length... En el foro Hardware, firmware and software help |
hace 2 months | |
|
New belt tuning frequencies (98 / 92 Hz) - Discussion (is it... En el foro Hardware, firmware and software help |
hace 2 months |