Prusa3D Forum

Notifications

Clear all

Backfisch_in_3D

Skupina: Registrovaný

Přidal se: 2025/08/15

Active Member

	Also my printer now sometimes bluescreens on startup. It bee... In forum General discussion, announcements and releases	před 1 month
	This has also been the case even before installing 6.4.0-alp... In forum General discussion, announcements and releases	před 1 month
	If you have enabled the Expert mode in PrusaSlicer you can e... In forum Hardware, firmware and software help	před 2 months
	Both belts influence each other, there is no way around this... In forum Assembly and first prints troubleshooting	před 2 months
	My tape-measure measurements are roughly the same, but the g... In forum Hardware, firmware and software help	před 2 months
	I just tried re-tensioning to 98/92, and the gap this causes... In forum Hardware, firmware and software help	před 2 months
	Aha! That makes more sense! Didnt think that the belt length... In forum Hardware, firmware and software help	před 2 months
	New belt tuning frequencies (98 / 92 Hz) - Discussion (is it... In forum Hardware, firmware and software help	před 2 months

Fórum Statistiky

585 Fóra

68.6 K Témata

480.2 K Příspěvky

10 Online

77 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed