Prusa3D Forum

Notifications

Clear all

ayourk

Groupe: Enregistré

A(ont) rejoint: 2016/06/05

Reputable Member

	Personally, I prefer the SKF bearings. SKF LBBR-8-2LS beari... Dans le forum Others (Archive)	il y a 5 years
	Hello, I would like to use the cable chains too, the curren... Dans le forum Others (Archive)	il y a 7 years
	Re: STL file of first multi material extruder? Dans le forum Improvements (Archive)	il y a 7 years
	Aaron's build is full swap while mine is maintenance centric... Dans le forum Improvements (Archive)	il y a 7 years
	Nice connector work! I thought about using D-Sub connectors,... Dans le forum Improvements (Archive)	il y a 7 years
	... Also, along with the slip out hotend mods to extruder-bo... Dans le forum Improvements (Archive)	il y a 7 years
	is somebody planning an adaptation for the MK3 ? Are the m... Dans le forum Improvements (Archive)	il y a 7 years
	➡ ok, so this is only a device that reads the PT100 di... Dans le forum Improvements (Archive)	il y a 7 years
	I've been working on a mount for the Titan Aero for the MK2/... Dans le forum Improvements (Archive)	il y a 7 years
	Are there any new models for the MK2S version released yet? ... Dans le forum Improvements (Archive)	il y a 7 years
	The clone made with 3030 AL profiles might offer a good test... Dans le forum Improvements (Archive)	il y a 8 years
	Are there any new models for the MK2S version released yet? ... Dans le forum Improvements (Archive)	il y a 8 years
	I personally have some Hiwin MGN9C2R400Z0CM with appropriate... Dans le forum Improvements (Archive)	il y a 8 years
	Check out this item on Thingiverse. Dans le forum Improvements (Archive)	il y a 8 years
	Hi, I am interested in printing Ultem 9085 with my i3 mk2 (... Dans le forum Improvements (Archive)	il y a 8 years
	Will Rambo case for X & Y works great if I have a) Igus ... Dans le forum Improvements (Archive)	il y a 8 years
	has anyone had a problem with the chain mount to the extrude... Dans le forum Improvements (Archive)	il y a 8 years
	Ayour: can I use std chain links or I must use full range ve... Dans le forum Improvements (Archive)	il y a 8 years
	Hi Aaron That is great, thank you. Just a couple of minor ... Dans le forum Improvements (Archive)	il y a 8 years
	I would like to revive this thread. Is anyone using a 40mm ... Dans le forum Improvements (Archive)	il y a 8 years

Page 1 / 14 Suivant

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

19 En-ligne

67.9 K Membres

Le dernier des messages: Prusa Core One - Intial thoughts...... Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé