ayourk – Aktivita – Prusa3D Forum

Notifications

Clear all

ayourk

Skupina: Registrovaný

Přidal se: 2016/06/05

Reputable Member

	Have you double checked that you have the newer style Hot-En... In forum Improvements (Archive)	před 10 years
	Hi guys ... Also i don't see a way to use them with the Y ... In forum Improvements (Archive)	před 10 years
	There are occasions I use "Cleaning" filament to push throug... In forum Others (Archive)	před 10 years
	This is what I use. 207 on the Z axis might be a bit much f... In forum Software (Archive)	před 10 years
	I've been working on some alignment sticks and was wondering... In forum Others (Archive)	před 10 years
	Here are some questons: What slicer do you like to use? A... In forum Others (Archive)	před 10 years
	On my Octopi, I prefer to NOT use my SD card and just store ... In forum Software (Archive)	před 10 years
	According to my counts, there are a total of 10 LM8UU bearin... In forum Others (Archive)	před 10 years
	MK2 Alignment Sticks In forum Improvements (Archive)	před 10 years
	I personally have never tried to use Simplify3D over USB. I... In forum General discussion, announcements and releases	před 10 years
	A good extruder retraction can also help some with the ooze. In forum Software (Archive)	před 10 years
	I did start using my MK2 printer via SD card that came with ... In forum Software (Archive)	před 10 years
	I'm not opposed to having the hotend fan on the front. The ... In forum Improvements (Archive)	před 10 years
	I 2nd that this is a very important link to have bookmarked.... In forum Others (Archive)	před 10 years
	Due to the clearance issues I noted above, I went ahead and ... In forum Improvements (Archive)	před 10 years
	As I'm interested in using cable chains, I went ahead and pr... In forum Improvements (Archive)	před 10 years
	Is that the link above that you worked on? Yes. I did it a... In forum Software (Archive)	před 10 years
	I've seen this problem in my printer once. I tightened up t... In forum Hardware, firmware and software help	před 10 years
	So far, I've found ColorFabb HT as a good alternative to ABS... In forum Prusa i3 kit (Archive)	před 10 years
	Of course I wouldn't mind mods. That's the whole point of sh... In forum Improvements (Archive)	před 10 years

Stránka 12 / 14 Předchozí Další

Fórum Statistiky

598 Fóra

70.9 K Témata

497.1 K Příspěvky

12 Online

82.3 K Uživatelé

Poslední Příspěvek: Small feature shrinkage with Polymaker PC-max Nový Uživatel: jbpr Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed