ayourk – Activité – Prusa3D Forum

Notifications

Clear all

ayourk

Groupe: Enregistré

A(ont) rejoint: 2016/06/05

Reputable Member

	Have you double checked that you have the newer style Hot-En... Dans le forum Improvements (Archive)	il y a 8 years
	Hi guys ... Also i don't see a way to use them with the Y ... Dans le forum Improvements (Archive)	il y a 8 years
	There are occasions I use "Cleaning" filament to push throug... Dans le forum Others (Archive)	il y a 8 years
	This is what I use. 207 on the Z axis might be a bit much f... Dans le forum Software (Archive)	il y a 8 years
	I've been working on some alignment sticks and was wondering... Dans le forum Others (Archive)	il y a 8 years
	Here are some questons: What slicer do you like to use? A... Dans le forum Others (Archive)	il y a 8 years
	On my Octopi, I prefer to NOT use my SD card and just store ... Dans le forum Software (Archive)	il y a 8 years
	According to my counts, there are a total of 10 LM8UU bearin... Dans le forum Others (Archive)	il y a 8 years
	MK2 Alignment Sticks Dans le forum Improvements (Archive)	il y a 8 years
	I personally have never tried to use Simplify3D over USB. I... Dans le forum General discussion, announcements and releases	il y a 8 years
	A good extruder retraction can also help some with the ooze. Dans le forum Software (Archive)	il y a 8 years
	I did start using my MK2 printer via SD card that came with ... Dans le forum Software (Archive)	il y a 8 years
	I'm not opposed to having the hotend fan on the front. The ... Dans le forum Improvements (Archive)	il y a 8 years
	I 2nd that this is a very important link to have bookmarked.... Dans le forum Others (Archive)	il y a 8 years
	Due to the clearance issues I noted above, I went ahead and ... Dans le forum Improvements (Archive)	il y a 8 years
	As I'm interested in using cable chains, I went ahead and pr... Dans le forum Improvements (Archive)	il y a 8 years
	Is that the link above that you worked on? Yes. I did it a... Dans le forum Software (Archive)	il y a 8 years
	I've seen this problem in my printer once. I tightened up t... Dans le forum Hardware, firmware and software help	il y a 8 years
	So far, I've found ColorFabb HT as a good alternative to ABS... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Of course I wouldn't mind mods. That's the whole point of sh... Dans le forum Improvements (Archive)	il y a 8 years

Page 12 / 14 Précédent Suivant

Statistiques du forum

561 Forums

63.1 K Sujets

444 K Messages

21 En-ligne

68.1 K Membres

Le dernier des messages: Some layers not lining up when slicing Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé