ayourk – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

ayourk

Gruppe: Registriert

Beigetreten: 2016/06/05

Reputable Member

	Have you double checked that you have the newer style Hot-En... Im Forum Improvements (Archive)	Vor 8 years
	Hi guys ... Also i don't see a way to use them with the Y ... Im Forum Improvements (Archive)	Vor 8 years
	There are occasions I use "Cleaning" filament to push throug... Im Forum Others (Archive)	Vor 8 years
	This is what I use. 207 on the Z axis might be a bit much f... Im Forum Software (Archive)	Vor 8 years
	I've been working on some alignment sticks and was wondering... Im Forum Others (Archive)	Vor 8 years
	Here are some questons: What slicer do you like to use? A... Im Forum Others (Archive)	Vor 8 years
	On my Octopi, I prefer to NOT use my SD card and just store ... Im Forum Software (Archive)	Vor 8 years
	According to my counts, there are a total of 10 LM8UU bearin... Im Forum Others (Archive)	Vor 8 years
	MK2 Alignment Sticks Im Forum Improvements (Archive)	Vor 8 years
	I personally have never tried to use Simplify3D over USB. I... Im Forum General discussion, announcements and releases	Vor 8 years
	A good extruder retraction can also help some with the ooze. Im Forum Software (Archive)	Vor 8 years
	I did start using my MK2 printer via SD card that came with ... Im Forum Software (Archive)	Vor 8 years
	I'm not opposed to having the hotend fan on the front. The ... Im Forum Improvements (Archive)	Vor 8 years
	I 2nd that this is a very important link to have bookmarked.... Im Forum Others (Archive)	Vor 8 years
	Due to the clearance issues I noted above, I went ahead and ... Im Forum Improvements (Archive)	Vor 8 years
	As I'm interested in using cable chains, I went ahead and pr... Im Forum Improvements (Archive)	Vor 8 years
	Is that the link above that you worked on? Yes. I did it a... Im Forum Software (Archive)	Vor 8 years
	I've seen this problem in my printer once. I tightened up t... Im Forum Hardware, firmware and software help	Vor 8 years
	So far, I've found ColorFabb HT as a good alternative to ABS... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Of course I wouldn't mind mods. That's the whole point of sh... Im Forum Improvements (Archive)	Vor 8 years

Seite 12 / 14 Vorherige Nächstes

Forums-Statistiken

566 Foren

63.1 K Themen

444 K Beiträge

23 Online

68.1 K Mitglieder

Letzter Beitrag: Issues printing tall thin print in ASA Unser neuestes Mitglied: etiennep Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen