audry – Activité – Prusa3D Forum

Notifications

Clear all

audry

Groupe: Enregistré

A(ont) rejoint: 2022/07/29

Eminent Member

	When using 3D print for technical parts (not flame spitting ... Dans le forum General discussion, announcements and releases	il y a 3 months
	No I expect to have one supplier that takes responsibility o... Dans le forum General discussion, announcements and releases	il y a 3 months
	As long as money is concerned, Prusa can sell under his own ... Dans le forum General discussion, announcements and releases	il y a 3 months
	I won’t buy anything until: -Prusa propose an upgrade under ... Dans le forum General discussion, announcements and releases	il y a 3 months
	I am a litlle bit less convinced Core One will not be INDX u... Dans le forum General discussion, announcements and releases	il y a 3 months
	I didn’t said there will never be any multi-head on Prusa Co... Dans le forum General discussion, announcements and releases	il y a 3 months
	I didn’t said there will never be any multi-head on Prusa Co... Dans le forum General discussion, announcements and releases	il y a 3 months
	I am not convinced Prusa will introduce soon INDX upgrade t... Dans le forum General discussion, announcements and releases	il y a 3 months
	Would like to have some kind of associativity between the CA... Dans le forum General discussion, announcements and releases	il y a 3 years
	Thanks Tried 2.5.0 Alpha 3 What works now: Filament start... Dans le forum PrusaSlicer	il y a 4 years
	FLOW RATE ignored in 2.5.0 Alpha 2 Dans le forum PrusaSlicer	il y a 4 years

Page 2 / 2 Précédent

Statistiques du forum

595 Forums

70.4 K Sujets

492.7 K Messages

18 En-ligne

81.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé