Prusa3D Forum

Notifications

Clear all

Art in Flight

Groupe: Enregistré

A(ont) rejoint: 2020/04/03

Active Member

	Exactly what I needed, thank you! Dans le forum Hardware, firmware and software help	il y a 2 years
	Power and Ground wire order for MK2 Heatbed Dans le forum Hardware, firmware and software help	il y a 2 years
	Prusa Logo Test Print Fails Same Place Every Time Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@bobstro That's great, thank you! Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@bobstro This looks like it could be a good option as this t... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@jullrey Thanks for sharing your idea. Unfortunately we have... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@augusto I'm sure there are groups in Montreal operating at ... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@amcdonnough With the extremely limited supply of clear plas... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@estevyn Unfortunately shipping delays rule this option out ... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@augusto We're located in the Greater Toronto Area. We are a... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@joantabb I'm starting a GoFundMe to raise money to order a ... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@joantabb Thank you, these would work with one of the groups... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	I found some. Grimco has a variety of options. You'll have t... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	@joantabb You are correct. I just laminated a sheet to test ... Dans le forum Coronavirus (COVID-19)	il y a 4 years
	Elastic Bands in Canada Dans le forum Coronavirus (COVID-19)	il y a 4 years
	I've been thinking about using Laminate sheets. You can purc... Dans le forum Coronavirus (COVID-19)	il y a 4 years

Statistiques du forum

535 Forums

59.8 K Sujets

428 K Messages

15 En-ligne

64.2 K Membres

Le dernier des messages: Filament stuck inside Nextruder nozzle help Notre nouveau membre: LandoC Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé