|
I ordered some extra springs from prusa, but they seem to st... En el foro General discussion, announcements and releases |
hace 6 years |
|
Same.
Seems to occur randomly, so it is difficult to find ou... En el foro Hardware, firmware and software help |
hace 6 years |
|
4. Loosen the bondtech gear tension a bit so that the filame... En el foro General discussion, announcements and releases |
hace 6 years |
|
I think Prusa gave us the tools but not the way how they wor... En el foro General discussion, announcements and releases |
hace 6 years |
|
Agree.
Things I changed:
1. The long tube (orange) to 4/2.... En el foro General discussion, announcements and releases |
hace 6 years |
|
Selector motor switched off by itself after some time En el foro Hardware, firmware and software help |
hace 6 years |
|
Same.
I contacted Live chat and they sent me a new sensor v... En el foro General discussion, announcements and releases |
hace 6 years |
|
I tried soluble material but the result is not good.
I used ... En el foro General discussion, announcements and releases |
hace 6 years |
|
Another cause is that the MMU is tilted at an angle. So grav... En el foro General discussion, announcements and releases |
hace 6 years |
|
Thanks peter. Yes, that's what I meant.
Hmm... last time I ... En el foro General discussion, announcements and releases |
hace 6 years |
|
There is no filament out detection, isn't it? En el foro General discussion, announcements and releases |
hace 6 years |
|
My filament sensor was burnt En el foro General discussion, announcements and releases |
hace 6 years |
|
Agree with OP. I asked for the same before.
Yes, MMU single... En el foro General discussion, announcements and releases |
hace 6 years |
|
I think it is due to stringing too though I found nothing . ... En el foro General discussion, announcements and releases |
hace 6 years |
|
Steel ball does not fall En el foro General discussion, announcements and releases |
hace 6 years |
|
Clever! En el foro General discussion, announcements and releases |
hace 6 years |
|
Thanks En el foro General discussion, announcements and releases |
hace 6 years |
|
Firmware update question En el foro General discussion, announcements and releases |
hace 6 years |
|
Suggestion: Manual mode En el foro General discussion, announcements and releases |
hace 6 years |
|
Same here.
I have nearly managed all issues, loading, unloa... En el foro General discussion, announcements and releases |
hace 6 years |
