|
I ordered some extra springs from prusa, but they seem to st... Nel forum General discussion, announcements and releases |
7 years fa |
|
Same.
Seems to occur randomly, so it is difficult to find ou... Nel forum Hardware, firmware and software help |
7 years fa |
|
4. Loosen the bondtech gear tension a bit so that the filame... Nel forum General discussion, announcements and releases |
7 years fa |
|
I think Prusa gave us the tools but not the way how they wor... Nel forum General discussion, announcements and releases |
7 years fa |
|
Agree.
Things I changed:
1. The long tube (orange) to 4/2.... Nel forum General discussion, announcements and releases |
7 years fa |
|
Selector motor switched off by itself after some time Nel forum Hardware, firmware and software help |
7 years fa |
|
Same.
I contacted Live chat and they sent me a new sensor v... Nel forum General discussion, announcements and releases |
7 years fa |
|
I tried soluble material but the result is not good.
I used ... Nel forum General discussion, announcements and releases |
7 years fa |
|
Another cause is that the MMU is tilted at an angle. So grav... Nel forum General discussion, announcements and releases |
7 years fa |
|
Thanks peter. Yes, that's what I meant.
Hmm... last time I ... Nel forum General discussion, announcements and releases |
7 years fa |
|
There is no filament out detection, isn't it? Nel forum General discussion, announcements and releases |
7 years fa |
|
My filament sensor was burnt Nel forum General discussion, announcements and releases |
7 years fa |
|
Agree with OP. I asked for the same before.
Yes, MMU single... Nel forum General discussion, announcements and releases |
7 years fa |
|
I think it is due to stringing too though I found nothing . ... Nel forum General discussion, announcements and releases |
7 years fa |
|
Steel ball does not fall Nel forum General discussion, announcements and releases |
7 years fa |
|
Clever! Nel forum General discussion, announcements and releases |
7 years fa |
|
Thanks Nel forum General discussion, announcements and releases |
7 years fa |
|
Firmware update question Nel forum General discussion, announcements and releases |
7 years fa |
|
Suggestion: Manual mode Nel forum General discussion, announcements and releases |
7 years fa |
|
Same here.
I have nearly managed all issues, loading, unloa... Nel forum General discussion, announcements and releases |
7 years fa |
