Activity
 
Notifications
Clear all
Aravon
Aravon
Group: Registered
Joined: 2017/09/25
Estimable Member
4
I ordered some extra springs from prusa, but they seem to st...

In forum General discussion, announcements and releases

6 years ago
Same. Seems to occur randomly, so it is difficult to find ou...

In forum Hardware, firmware and software help

6 years ago
4. Loosen the bondtech gear tension a bit so that the filame...

In forum General discussion, announcements and releases

6 years ago
I think Prusa gave us the tools but not the way how they wor...

In forum General discussion, announcements and releases

6 years ago
Agree. Things I changed: 1. The long tube (orange) to 4/2....

In forum General discussion, announcements and releases

6 years ago
Selector motor switched off by itself after some time

In forum Hardware, firmware and software help

6 years ago
Same. I contacted Live chat and they sent me a new sensor v...

In forum General discussion, announcements and releases

6 years ago
I tried soluble material but the result is not good. I used ...

In forum General discussion, announcements and releases

6 years ago
Another cause is that the MMU is tilted at an angle. So grav...

In forum General discussion, announcements and releases

6 years ago
Thanks peter. Yes, that's what I meant. Hmm... last time I ...

In forum General discussion, announcements and releases

6 years ago
There is no filament out detection, isn't it?

In forum General discussion, announcements and releases

6 years ago
My filament sensor was burnt

In forum General discussion, announcements and releases

6 years ago
Agree with OP. I asked for the same before. Yes, MMU single...

In forum General discussion, announcements and releases

6 years ago
I think it is due to stringing too though I found nothing . ...

In forum General discussion, announcements and releases

6 years ago
Steel ball does not fall

In forum General discussion, announcements and releases

6 years ago
Clever!

In forum General discussion, announcements and releases

6 years ago
Thanks

In forum General discussion, announcements and releases

6 years ago
Firmware update question

In forum General discussion, announcements and releases

6 years ago
Suggestion: Manual mode

In forum General discussion, announcements and releases

6 years ago
Same here. I have nearly managed all issues, loading, unloa...

In forum General discussion, announcements and releases

6 years ago
Page 2 / 7
Share: